Jonassus Drive
|
User Manual -
|
| ||
Cabzeus
|
User Manual -
|
| ||
|
Firmware -
( v2.0 - build 3 ) |
| ||
|
Update procedure :
* This update procedure requires a factory reset which will erase the presets stored in your pedal. To avoid losing your presets you can first save your presets as 'Local Preset' in your computer and later restore it back to your pedal. Do that before you perform the update steps below. 1. Download and install editor software CabsLab 2.0.0 (or higher). 2. Download firmware v.2.0 3. Do Firmware Update : - Hold down the preset selector knob on power up. Release when both LED 1 and 4 light up. - Connect the pedal to your computer and start CabsLab 2.0.0. - When prompted, browse for the firmware file you've just downloaded and start the update. 4. Do Factory Reset - Menu >> Factory Reset. (If you encountered errors at this step, reboot the pedal and try again). 5. Reboot the pedal - DONE. |
|
Software -
( Windows ) |
| ||||
|
Software -
( Mac OS X ) |
|
(!) Please read the Installation Guide (included in the zip file) first before installing.
| ||
OS Compatibility
10.10 (Yosemite)
10.9 (Maverick).
- Windows : XP, 7, 8.x, 10
- Mac : 10.12 (Sierra)
10.10 (Yosemite)
10.9 (Maverick).
Specular Reverb V3
|
User Manual -
|
| ||
Clockwork Delay V3
|
User Manual -
|
| ||
Specular Tempus
|
User Manual -
|
| ||
|
Firmware -
(v3.8 - build 12) Post date : Jan. 03, 2019 |
|
<!> If your pedal still runs on a firmware that is lower than V3.0 please contact us. Do not attempt to update to V3.8 directly!
Take a little time to go over this release note to get you started with the new stuff. - v3.8 build 7 fixed a bug related to tap-tempo operation via MIDI and via footswitch B. - v.3.8 build 8 fixed the 'last-used' preset loading error on power up. - v3.8 build 9 fixed global tempo bug. - v3.8 build 10 fixed FX-Loop bug. - v3.8 build 11 fixed Global Kill-Dry bug. - v3.8 build 12 fixed tempo-related bugs and made Shimmer and Swell algos more robust. | ||||||
|
Update procedure :
1. Download and install editor software SpecLab 3.1.8 or higher. 2. Download the firmware file. 3. Do Firmware Update : - Hold down both footswitches on power up. Release when both LED A and B light up. - Connect the pedal to your computer and start the editor software. - When prompted, browse for the firmware file you've just downloaded and start the update. 4. Do Library Update - Menu >> Library Update. 5. Reboot the pedal - DONE. < ! > The first thing you should do after the update is reconfigure the Global Configuration and MIDI Configuration (if you use MIDI), otherwise your pedal may not work properly. |
|
Software -
( Windows ) |
|
| ||||
|
Software -
( Mac OS X ) |
|
(!) Please read the Installation Guide (included in the zip file) first before installing.
| ||